Virtual desktops over VNC

Introduction

The SRCF desktop server shell.srcf.net has VNC server software installed (we’re using TightVNC). This allows you run a graphical desktop on our server, and connect to it remotely.

However, TightVNC does not encrypt sessions, so you must connect through SSH in order to avoid possible eavesdropping over the internet.

To start it up, you’ll first need to be able to connect over SSH to the SRCF desktop server. Linux and Mac should already provide the ssh terminal command; Windows users may download PuTTY for a native SSH client.

Setting a VNC password

SSH to shell.srcf.net using your SRCF username and password (SSH keys for your account are also valid), then run the vncpasswd command:

    spqr2@pip:~$ vncpasswd
    Using password file /home/spqr2/.vnc/passwd
    Password:
    Verify:
    Would you like to enter a view-only password (y/n)? n

You can say no to a view-only password, for this use case it’s unlikely to be useful.

Starting a new session

To start a new VNC server process in the background:

    spqr2@pip:~$ vncserver -geometry 1920x1080
    New 'X' desktop is pip:12

    Starting applications specified in /home/spqr2/.vnc/xstartup
    Log file is /home/spqr2/.vnc/pip:12.log

Geometry is of the form <width>x<height> and may be customised as desired (the VNC window cannot be resized after you have started the VNC server).

Take a note of the :12 in the output; this is the display number assigned automatically to your VNC server and could be any two-digit number.

Add 5900 to the display number to obtain the port number (in this example, the port number is 5912).

Tunneling over SSH

As noted above, VNC server connections are insecure. Instead, you should use an SSH tunnel – this provides encryption over the wire for free, and allows you to securely authenticate to, and make use of, your VNC server instance.

The aim is to forward your VNC port on the desktop server, to a port of your choosing on your local machine.

Linux and Mac

Back on your local machine, SSH to shell.srcf.net again, but request forwarding for your chosen port:

    you@home:~$ ssh -N -L 5901:localhost:5912 shell.srcf.net

Replace 5912 with the port number for your VNC server (the display number shown when you started vncserver, plus 5900).

Windows

In PuTTY’s main window, go to ‘‘Connection’’ > ‘‘SSH’’ > ‘‘Tunnels’'.

Under ‘‘Add new forwarded port’', set the source port to 5901 (the local port on your home machine), and the destination to localhost:5912 replacing 5912 with the port number for your VNC server (the display number shown when you started vncserver, plus 5900).

Connecting with a VNC client

At this stage, you should now have port 5901 on your local machine acting as a tunnel to your VNC server instance on shell.srcf.net. The last step is to actually point your VNC client to it.

If you don’t have a VNC client installed, this Ubuntu page lists some possibilities, though may be out of date.

Start your client and connect to localhost:5901 (this is relative to your home machine). If all is well, you should be prompted for the VNC password you created at the start, after which you’ll be greeted with your new desktop.

You can disconnect and later reconnect, and the state should be preserved.

Ending the session

Back over SSH to shell.srcf.net:

    spqr2@pip:~$ vncserver -kill :12

Replace :12 with the port number for your VNC server.

Make sure to close any running programs over VNC beforehand, as this will forcefully kill them too.